If you are going to have a sawmill in Framingham, MA, you have to learn about all of secrets to turning ordinary logs into usable pieces of lumber for woodworking projects. The trick is to first learn about the wood cutting patterns in Framingham, MA, that sawyers have been using for years. The following is a list of a few to get started with:

Create a Beam

To make a long, solid beam that can be used for supporting a roof or other heavy structure, you must first start out with a hardwood log. Trim a strip of wood off of one side. Then, turn the log, and do the same to the remaining sides. This will leave you with one center piece. If the log is fairly thick, you can often salvage the excess wood that comes off.

Plain Boards

One of the easiest wood cutting patterns in Framingham, MA, to do is to make simple boards with a technique called “plain sawing.” The log is simply fed through the sawmill in Framingham, MA, one swipe at a time. This makes long slices that can be trimmed down to smaller sizes.

Slabs

When there is quite a bit of lumber to process, but not very much time to get it all done in, it helps to do some quick slabs that can be turned into other more intricate shapes later on. They can also be kept whole for building rustic furniture. To make a slab out of a log, run the bandsaw blade close to the edges. It should only go in far enough to trim off the bark and the outer portion of the wood that isn’t useful.

L-Shapes

After you get a little more experience in using a sawmill, you might want to try your hand at doing l-shaped lumber. First, one side of the log is trimmed off. Then, on the opposite side of the log, another deeper cut is made to remove some of the excess wood. But the cut doesn’t go all the way through the bottom of the log. Instead, you will have to measure the appropriate depth to reach across with your sawmill to get the corner that you desire.